Flange Insulation Kits - sealing selections for applications where cathodic corrosion is a concern

Corrosion has long been natures most destructive element, but with LoneStar flange insulation products this costly profit robbing item can all but be eliminated. LoneStar engineered insulation products, of consistent high quality, can be used to control and confine electrolytic corrosion in almost every piping system. LoneStar insulation products are manufactured from materials with superior high dielectric strength, low water absorption and chemical stability to maintain the high quality required in refinery and chemical plant applications. Hydrocarbon exposure, weathering and salt water are no problem for LoneStar insulating materials. LoneStar quality assurance and high production rate allow our customers to economically protect and lengthen the service life of equipment with little or no down time due to electrolysis.

LoneStar manufactures a full line of standard flange insulation sets including Type F (Ring) gaskets, Type E (Full Face) gaskets and Type D (API Ring Joint) gaskets. LoneStar Type F and E gaskets are manufactured from 1/8" thick fabric based phenolic (Nema Grade CE) sheet with either no coating (plain faced) or a Nitrile rubber coating on both faces. Type F & E gaskets are also available in Compressed Non-Asbestos with superior electrical insulation qualities.


Insulation Kits

Flange insulating sets are packaged for one flanged joint, including gasket, sleeves and washers. Each flange set is securely packaged in a cardboard box, clearly labelled as to size, ASA Rating, style and material. Either polyethylene or phenolic sleeves are available with these insulating sets. Polyethylene sleeves are standard and will be furnished unless otherwise specified.

Type D

(API Ring Joint) - gaskets are insulating ring joint gaskets made to fit the ring groove of Ring Type Joint flanges. The Type D central gasket is made of medium weave fabric-reinforced phenolic, manufactured to ASA (ANSI) gasket dimensions. Properties are similar to those of phenolic flat central gaskets and are available in the basic octagonal shapes. Oval shapes can be ordered by special request. When installing Type D gaskets, it is also recommended that tape be wrapped around the outside of the flange to prevent foreign material from lodging between the exposed portions and causing "shorting out" of the flanges. Alignment pins should be used whenever possible to assure proper alignment of flanges when installing all flange insulation sets. Pins should be a minimum of 3/32" (2.38mm) larger than the bolt size.

Type E

(Full Face) - gaskets are designed for full protection of flanges and have the same outside diameter as the flange. Each gasket has precision-located bolt holes. Upon installation, it is recommended that tape be wrapped around the outside of the flange to prevent foreign material from lodging between the exposed portions and causing "shorting out" of the flanges. All Type E gaskets are easily centered with the flange inside diameter. Gaskets with slightly larger outside diameters are available on request.

Type F

(Ring) - gaskets are designed to fit the raised face portion of flanges. The outside diameter of the gasket is slightly smaller than the inside diameter of the bolt hole circle. The outside diameter is designed for alignment by the insulating sleeves. The central gaskets are available in the same materials as Type E. Upon installation, it is recommended that tape be wrapped around the outside of the flange to prevent foreign material from lodging between the exposed portions and causing "shorting out" of the flanges.

© 2024 Copyright: LSP Holding (UK) LTD